Журналы →  Gornyi Zhurnal →  2015 →  №3 →  Назад

SCIENCE AND INDUSTRY
Название Scientific-technical basis of methodology for forecasting maximum allowable face output in gassy coal mining
DOI 10.17580/gzh.2015.03.01
Автор Slastunov S. V., Karkashadze G. G., Mazanik E. V., Lupiy M. G.
Информация об авторе

Author 1:
Name & Surname: Slastunov S. V.
Company: Mining Institute, National University of Science and Technology MISiS (Moscow, Russia)
Work Position: Head of department, Professor Scientific Degree: Doctor of Engineering Sciences
Contacts: slastunov@mail.ru


Author 2:
Name & Surname: Karkashadze G. G.
Company: Mining Institute, National University of Science and Technology MISiS (Moscow, Russia)
Work Position: Professor
Scientific Degree: Doctor of Engineering Sciences


Author 3:
Name & Surname: Mazanik E. V.
Company: SUEK-Kuzbass (Leninsk-Kuznetsky, Russia)
Work Position: Director for Aerodynamic Safety of Mines
Scientific Degree: Candidate of Engineering Sciences


Author 4:
Name & Surname: Lupiy M. G.
Company: SUEK-Kuzbass (Leninsk-Kuznetsky, Russia)
Work Position: Director of mine
Scientific Degree: Candidate of Engineering Sciences

Реферат

The authors appreciate participation of K. S. Kolikov, Doctor of Engineering Sciences, Professor, MISiS, in this research work. The article presents methodology for forecasating maximum allowable face output based on gas criterion. The calculations use differential equations of methane mass transfer in terms of partial derivatives. The source information was the data on actual ground conditions in Kirov Mine, SUEK-Kuzbass. The authors adduce the calculation results that allow estimating effect of face conveyor velocity, fraction composition of broken coal and face length on coal production. The developed methodology enables a tentative forecast of gas content of air in the face area, which is required in planning extraction sites or production units. The forecast methodology for maximum allowable face output is meant for routine and long-term production planning.
The work was supported by the RF Ministry of Education and Science in the framework of the governmental assignment under agreement no. 14. VVV.21.0142.14.575.21.0025 as of June 23, 2014.

Ключевые слова Production face, coal, methane, broken coal, face conveyor velocity, production face length, production face output
Библиографический список

1. Rukovodstvo po proektirovaniyu ventilyatsii ugolnykh shakht (Guidance for coal mine ventilation designing). Donbass : Makeevka State Scientific-Research Institute on Safety of Works in Mining Industry, 1989. 319 p. (in Russian)
2. Polubarinova-Kochina P. Ya. O neustanovivsheysya filtratsii gaza v ugolnom plaste (About unsetted gas filtration in coal-seam). Prikladnaya matematika i mekhanika = Journal of Applied Mathematics and Mechanics. 1953. Vol. 17, No. 6. pp. 735–738.
3. Karkashadze G. G., Lupiy M. G., Mazanik E. V. Model filtratsii metana iz ugolnogo plasta v ochistnoy zaboy (Model of methane filtration from coal-seam into breakage face). Gornyy Informatsionno-Analiticheskiy Byulleten. Metan = Mining Information-Analytical Byulletin. Methane. 2009. Special issue No. 11. pp. 297–300.
4. Slastunov S. V., Karkashadze G. G., Mazanik E. V. Metodika i rezultaty izmereniya plastovogo davleniya metana i sorbtsionnykh svoystv ugolnogo plasta (Method and results of measurement of methane seam pressure and coal-seam sorption properties). Gazovaya promyshlennost = Gas industry. 2012. Special issue. pp. 48–49.

Language of full-text русский
Полный текст статьи Получить
Назад