Журналы →  Tsvetnye Metally →  2018 →  №11 →  Назад

Название Copper recovery from slags during gas flush reduction
DOI 10.17580/tsm.2018.11.03
Автор Komkov А. А., Kamkin R. I., Kuznetsov A. V., Karyaev V. I.
Информация об авторе

MISiS National University of Science and Technology, Moscow, Russia:

А. А. Komkov, Associate Professor at the Department of Non-Ferrous Metals and Gold, e-mail: akomkov@yandex.ru
V. I. Karyaev, Postgraduate Student at the Department of Non-Ferrous Metals and Gold, e-mail: karyaev@mailnord.ru


LLC “BASF”, Moscow, Russia:
R. I. Kamkin, Head of the Technical Centre in Russia and CIS, e-mail: rostislav.kamkin@basf.com


LLC “Nord Engineering”, Moscow, Russia:
A. V. Kuznetsov, Technical Director, e-mail: kuznetsov@mailnord.ru


This paper describes an experimental study of the kinetics and essence of copper losses during gas flush reduction of copper smelter slags. The paper contains experimental data and the results of related calculations that show how the copper reduction rate changes during gas flush reduction of copper smelter slags with gas mixtures characterized by different CO/CO2 ratios. The actual values obtained, which indicate how much copper remained in the slags after reduction, were compared with the copper content in the slags if the process is reversed, i.e. during copper saturation of slags. Consistent discrepancies were found, which cannot just be attributed to possible experimental error. The authors provide their suggestions of what could have caused the discrepancies. Based on the metallography data, it was established th at the main factor contributing to copper losses during gas flush reduction of copper smelter slags includes mechanical losses, which are attributed to the presence in the slag of a great number of suspended fine (3–4 μm) particles of the alloy with a composition identical to the bottom metallic phase. The analysis showed that, during the experiments, mechanical losses accounted for 13 to 69% of total copper losses. The experimental data obtained (allowing for the mechanical losses) were compared with the values obtained through thermodynamic calculations of the slag reduction process based on the iron oxide activity values of 0.35 and 0.45, which are consistent with real copper smelter slags. The comparison indicated consistency between experimental and calculated values, which supports the supposition about mechanical losses being a major factor in the total copper losses with slags.

Ключевые слова Slag reduction, reducing gas, solubility of copper, mechanical losses, suspended metal drops, sparging, copper recovery
Библиографический список

1. Pinin L. N. Understanding the process of reducing nickel converter slags with gaseous and liquid reducing agents: Extended abstract of PhD dissertation. Leningrad, 1980.
2. Dosmukhamedov N. K., Zholdasbay E. E., Nurlan G. B., Seytkulova Zh. B. Understanding the bahaviour of non-ferrous metals, iron and arsenic during reduction of copper-rich slags. Mezhdunarodnyy zhurnal prikladnykh i fundamentalnykh issledovaniy. 2016. No. 1–4. pp. 486–491.
3. Oleksiak B., Lipart J., Karbownik A., Burdzik R. Effects of a reducer type on copper flash smelting slag decopperisation. Metalurgiya. 2015. Vol. 54, Iss. 1. pp. 116–118.
4. Madej P., Kucharski M. Influence of temperature on the rate of copper recovery from the slag of the flash direct-to-blister process by a solid carbon reducer. Archives of metallurgy and materials. 2015. Vol. 60, Iss. 3. pp. 1664–1671.
5. Rusen A., Derin B., Geveci A., Topkaya Y. A. Investigation of Copper Losses to Synthetic Slag at Different Oxygen Partial Pressures in the Presence of Colemanite. JOM. 2016. Vol. 68, Iss. 9. pp. 2316–2322.
6. Davis B., Lebel T., Parada R., Parra R. Slag reduction kinetics of copper slags from primary copper production. Advances in Molten Slags, Fluxes, and Salts: Proceedings of the 10-th International Conference on Molten Slags, Fluxes and Salts. 2016. pp. 657–665.
7. Huaiwei Z., Xiaoyan S., Bo Z., Xin H. Reduction of Molten Copper Slags with Mixed CO – CH4 – Ar Gas. Metallurgical and Materials Transactions B. 2014. Vol. 45, Iss. 2. pp. 582–589.
8. Kucharski M., Sak T., Madej P., Wdrychowicz M., Mróz W. A Study on the Copper Recovery from the Slag of the Outokumpu Direct-to-Copper Process. Metallurgical and Materials Transactions B. 2014. Vol. 45, Iss. 2. pp. 590–602.
9. Komkov A. A., Kamkin R. I. Behaviors of copper and impurity elements during expulsion copper melt slags with CO – CO2 gas mixture. Tsvetnye Metally. 2011. No. 6. pp. 26–31.
10. Ladygo E. A. Regularities in the distribution of copper and nickel between the products of reduction melting: Dissertation ... of Candidate of Engineering Sciences. Moscow, 2003. 149 p.
11. Vaskevich A. D., Sorokin M. L., Kaplan V. A. A general thermodynamic model of copper solubility in slags. Tsvetnye Metally. 1982. No. 10. pp. 22–26.
12. Sorokin M. L., Andryushechkin N. A., Nikolaev A. G. Thermodynamics of the Cu–Fe system. Izvestiya vuzov. Tsvetnaya metallurgiya. 1996. No. 6. pp. 10–14.

Language of full-text русский
Полный текст статьи Получить