Журналы →  Gornyi Zhurnal →  2018 →  №9 →  Назад

DEVELOPMENT OF DEPOSITS
Название Investigation and development of high-bench blasting method with parallel close-spaced holes and wedging stemming
DOI 10.17580/gzh.2018.09.04
Автор Norov Yu. D., Nasirov U. F., Ochilov Sh. A.
Информация об авторе

Navoi Mining and Metallurgical Combinat, Navoi, Uzbekistan:

Yu. D. Norov, Head of Industrial Engineering and Innovation Department, Professor, Doctor of Engineering Sciences, yud.norov@ngmk.uz

 

Tashkent State Technical University, Tashkent, Uzbekistan:
U. F. Nasirov, Dean of the Faculty of Geologic Engineering and Mining, Doctor of Engineering Sciences
Sh. A. Ochilov, Senior Lecturer

Реферат

At the present time, all large open pit mines in the world predominantly tend towards benching at increased height. This approach enables better technical and economic performance of deep open pit mines, less number of haulage and mining horizons, higher slope of highwall, reduced stripping ratio and, finally, smaller volume of stripping. The continuous improvement of drilling and blasting methods is aimed at quality fragmentation of rocks in open pit mines with high benches. Among the practiced methods, it is most frequently recommended to use parallel close-spaced blasting. Efficiency of this method is explained by the fact that in the direct vicinity of such blastholes, at a distance of their half-spacing, cylindrical stress waves start to interact and generate a plane front. As a result, rock mass is largely saturated with blast energy, and fragmentation in the remote zones is intensified due to the increased stresses. At the Navoi Mining and Metallurgical Combinat, applicability of parallel close-spaced blasting at high benches of Muruntau open pit mine was studied. The blast pattern and sizes of explosive charges were calculated with respect to the physical and mechanical properties of rocks. Then, an experimental block of a high bench was subjected to large-scale blasting using the conventional and new (studied) methods. The comparison of the blasting outcomes showed that the parallel close-spaced blasting improved rock fragmentation quality along the whole height of the bench, which would increase productiveness of cutting and loading machines.

Ключевые слова High bench, blasting method, parallel close-spaced blast holes, wedging stemming, plane front, stress wave, efficient parameters, blast hole spacing, detonation product blocking
Библиографический список

1. Ilin S. A., Kovalenko V. S., Pastikhin D. V. Open method of mining: opportunities and ways. Gornyi Zhurnal. 2012. No. 2. pp. 37–40.
2. Viktorov S. D., Eremenko A. A., Zakalinskiy V. M., Mashukov I. V. Technology of large-scale blast undercutting at rockburst-hazardous Siberian ore deposits. Novosibirsk : Nauka, 2005. 212 p.
3. Norov Yu. D., Shemetov P. A., Zairov Sh. Sh., Tukhtashev A. B., Nasirov U. F., Bibik I. P. Improvement of Control Methods for Rock Fragmentation by Blasting. Bukhara : Bukhoro, 2011. 200 p.
4. Snitka N. P., Misliboev I. T., Karimov E. L. Energy-saving drilling-and-blasting technology for zones of rock mass weakening in deep open pit mines. Gornyi vestnik Uzbekistana. 2015. No. 2(61). pp. 7–11.
5. Norov Yu. D., Ochilov Sh. A. Problem of control of rock fragmentation quality under blast energy in open pit mining. Gornyi vestnik Uzbekistana. 2016. No. 4(67). pp. 17–23.
6. Rakishev B. R. Automated Design and Implementation of Large-Scale Blasts in Open Pit Mines. Almaty : Gylym, 2016. 340 p.
7. Nasirov U. F., Ochilov Sh. A., Ravshanova M. Kh. Theoretical investigation of hard rock crushing mechanism when blasting high benches. Izvestiya vuzov. Gornyi zhurnal. 2017. No. 3. pp. 38–44.
8. Gupta I. D., Trapathy G. R. Comparison of construction and mining blast with specific reference to structural safety. Indian Mining and Engineering Journal. 2013. Vol. 54, No. 4. pp. 13–17.
9. Akande J. M., Lawal A. I. Optimization of blasting parameters using regression models in ratcon and NSCE granite quarries, Ibadan, Oyo State, Nigeria. Geomaterials. 2013. Vol. 3, No. 1. pp. 28–37.
10. Inoue H., Sasaoka Т., Shimada H., Hamanaka A. Study on control of fragmentation size by changing blasting pattern at open pit metal mine. Proceedings of International Symposium on Earth Science and Technology. Fukuoka, 2014. pp. 214–217.
11. Isheysky V. A. About the grain-size distribution of blasted rock from different zones of destruction. Scientifi c Reports on Resource Issues. Freiberg : Technische University Bergakademie, 2014. pp. 202–207.
12. Duan Y., Xiong D., Yao L., Wang F., Xu G. Advanced technology for setting out of blastholes and measurement while drilling. Proceedings of the 11th International Symposium on Rock Fragmentation by Blasting (Fragblast 11). Sydney, 2015. pp. 593–598.
13. Viktorov S. D., Galchenko Yu. P., Zakalinsky V. M., Rubtsov S. K. Rock Breakage by Closely Spaced Charges. Moscow : Nauchtekhlitizdat, 2006. 275 p.
14. Ochilov Sh. A. Theoretical studies of mechanism of interaction between a pair of closely spaced blast holes. Gornyi vestnik Uzbekistana. 2017. No. 4(71). pp. 22–26.

Полный текст статьи Investigation and development of high-bench blasting method with parallel close-spaced holes and wedging stemming
Назад