Journals →  Tsvetnye Metally →  2017 →  #2 →  Back

BENEFICATION
ArticleName Some indicators of gold benefication on rinsing tools with deep sluices
DOI 10.17580/tsm.2017.02.05
ArticleAuthor Zashikhin A. V., Guryanov A. E., Ananenko K. E.
ArticleAuthorData

Institute of Chemistry and Chemical Technology (Siberian Branch RAS), Krasnoyarsk, Russia:

A. V. Zashikhin, Researcher of Soil Mastering Problems Laboratory, e-mail: obog2006@yandex.ru


LLC “Artel starateley Angara-Sever”, Krasnoyarsk, Russia:
A. E. Guryanov, Executive Officer

 

Siberian Federal University, Krasnoyarsk, Russia:
K. E. Ananenko, Assistant Professor of Benefication Chair

Abstract

This paper shows some results of statistical description and analysis of operation of fourteen hydroelevator rinsing tools with deep sluices, processing the placer deposits' gold-bearing sands. The life service of these tools is from one to four seasons. There was made an attempt of generalization and comparison of season-averaged indicators: granulometric characteristics of metal released in concentrate, sluice coefficient, theoretical extraction of metal and quantity of extracted metal in concentrate. There was carried out the statistic processing of averaged characteristics of the concentrates, obtained as a result of more than 3800 removals. There is shown the strong linear correlation between the indicators of calculation extraction and coarseness medians of gold particles. As a result, the chief engineer's service should pay attention on two specialintended rinsing tools. A close positive connection of average values of sluice coefficient, metal release and coarseness median with their standard deviation values was found and may be practically used for indicator fixing. A diagram method is offered for assessment of rinsing tools operation. It is based on calculation of arithmetic average parameter values at the end of the season and definition with their significant increasing by current (special) values. Assessment of these indicators, synchronized with sequence and order of raw material extraction is the most urgent. Generally the obtained results may be the part of new approaches and methods, aimed on increasing of efficiency and rationality of mining of placer gold-bearing deposits.

keywords Gold, placer deposits, benefication on sluices, extraction, sluice coefficient, coarseness median, statistics
References

1. Preys V. K. Equipment and technology for benefication of gold placer deposit sands : tutorial. Magadan : Kordis, 2002. 249 p.
2. Lavrov N. P. Tutorial for design of placer deposit mining : mining and benefication. Vostochnyy NII zolota i redkikh metallov. Magadan : Kordis, 2004. 135 p.
3. Matsuev L. N. Placer mining reference book. Issue 6. Benefication. Magadan : OTI sovnarkhoza, 1961. 191 p.
4. Lavrov N. P., Milentev V. V. Practical tutorial for exploitation of rinsing tools and heavy concentrate benefication plants. Vostochnyy NII zolota i redkikh metallov. Magadan : Kordis, 2005. 206 p.
5. Sivamohan R., Forssberg E. Principles of sluicing. International Journal of Mineral Processing. 1985. Vol. 15, No. 3, October. pp. 157–171.
6. Zamyatin O. V., Mankov V. M., Tomin V. S., Makurin A. V. Recommendations for gold-bearing sand benefication control. Irkutsk : Irgiredmet, 1991. 55 p.
7. Zamyatin O. V., Lopatin A. G., Sannikova N. P., Chugunov A. D. Benefication of gold-bearing sands and conglomerates. Moskva : Nedra, 1975. 232 p.
8. Kavchik B. K. Screen analysis and definition of granulometric characteristics of placer gold. Irkutsk : Irgiredmet, 2001. 11 p.
9. Vaulin O. V. Mining and benefication of gold placers : reference book. Bishkek : ROKIZOL, 2016. 622 p.
10. Subasinghe G. K. N. S. Optimal design of sluice-boxes for fine gold recovery. Minerals Engineering. 1993. Vol. 6, No. 11, November. pp. 1155–1165.
11. Barry A. Wills, James A. Finch. Wills' Mineral Processing Technology (Eighth Edition). An Introduction to the Practical Aspects of Ore Treatment and Mineral Recovery. Amsterdam : Elsevier, 2016. pp. 223–244.
12. Clarkson G., Clarkson R., Hitch M. Exploiting the malleability of gold for placer concentrate extraction and recovery. Minerals Engineering. 2016. Vol. 94, August. pp. 38–40.
13. Ofori-Sarpong G., Amankwah R. Comminution environment and gold particle morphology: effects on gravity concentration. Minerals Engineering. 2011. Vol. 24, No. 6. pp. 590–592.
14. Yukon Placer Mining Industry 2010–2014. Department of Energy, Mines and Resources ; compilers : Van Loon S., Bond J. D. Whitehorse, Yukon, Canada, 2014. Available at : http://ygsftp.gov.yk.ca/publications/yplacer/YPMI_2010-14_web.pdf
15. Griffith S. V. Alluvial Prospecting and Mining (Second Revised Edition). Chapter V – sluicing. Amsterdam : Elsevier Ltd., 1960. pp. 99–128.
16. Sadeghi M., Bazin C., Renaud M. Effect of wash water on the mineral size recovery curves in a spiral concentrator used for iron ore processing. International Journal of Mineral Processing. 2014. Vol. 129, 10 June. pp. 22–26.

Language of full-text russian
Full content Buy
Back